Printed Series 1L Tail Light Overlays - 2021+ Bronco (w/ LED Taillights)

Bigfoot / Sasquatch / Dark Smoke

$25.99

Printed Series 1L Tail Light Overlays - 2021+ Bronco (w/ LED Taillights)

$25.99

Bigfoot / Sasquatch design — custom printed overlay with tint built right in
Fits 2021+ Ford Bronco LED taillights — precision-cut for a factory-flush look
Printed and laminated in the USA — 2.5mil overlaminate protects against UV, water, and daily wear
Smokes and styles in one step — no separate tint film needed, the design IS the tint
Wet-apply vinyl — repositionable during install, permanent once set
Two smoke options — Dark Smoke or Light Smoke to match your build
Removable — won't damage your taillights when removed correctly

Printed Series 1L Tail Light Overlays

Bigfoot lives on your taillights now. Smoked, printed, and ready to turn heads on the trail.

Printed Bigfoot Tail Light Overlay installed on 2021+ Ford Bronco

More Than a Tint — It's a Statement

Standard tint overlays smoke your taillights and call it a day. The Printed Series goes further. Your chosen design is printed directly into the overlay film, so you get custom art and the smoked look at the same time — no layering, no gaps, no bubbles between films.

Our first design is Bigfoot / Sasquatch — a classic Pacific Northwest icon that fits perfectly on a Bronco. The full panel is covered, and the design blends with the taillight's natural translucency when lit at night.

Bronco LED taillight glowing at night with overlay applied

Pick Your Smoke Level

Dark Smoke — aggressive smoked look. The Bigfoot silhouette shows strongly during the day, taillights appear dramatically darker at rest.

Light Smoke — subtler tint. The design blends more naturally in daylight while still delivering the effect when the lights are on at night.

Both options use the same 2.5mil laminate top coat — weather-resistant and UV-stable for long-term outdoor use.

Printed overlay on 2021+ Bronco taillight — daytime look

Wet Install — Done in Under 30 Minutes

Clean the taillight surface — no Armor All, no residue
Mix a small spray bottle with 1–2 drops of dish soap + water
Wet the taillight and the back of the vinyl
Position the overlay and squeegee out the water from center to edge
Let it set for 24 hours before driving in rain

Optional: use StickerFab Application Fluid for a cleaner slide during positioning.

⚙️ Installation — Takes About 20–30 Minutes

Wet install method. Clean the taillight thoroughly, wet both surfaces with soapy water, position and squeegee. A felt-tip squeegee is recommended. Install in shade — direct sun heats the vinyl and makes repositioning harder. Allow 24 hours cure before washing. Removal: Apply Goo Gone, let it sit for a minute, then peel from a corner. Wipe the taillight clean with a fresh cloth. No damage to the OEM taillight surface.

FAQ

Does each kit cover both taillights? Yes — every order includes overlays for the driver side and passenger side.	Do these work with the stock LED taillights? Yes — specifically designed for the 2021+ Bronco LED taillight signature. Not for halogen taillights.
Will the design show when the lights are off? Yes — in Dark Smoke especially, the Bigfoot silhouette is visible during the day. Light Smoke is more subtle at rest.	Is this street legal? Tint laws vary by state. We recommend the Light Smoke option for maximum brightness retention and broad compliance.
Can I request a different design? Yes — contact us with your idea. Designs with mass appeal get listed for everyone.	How do I remove it? Apply Goo Gone, let it sit a minute, then peel from a corner. Wipe clean. No damage to the OEM lens.